Unnathi Groups Technology Reinvented

Epoxy Self level Flooring

Extremely easy to clean, seamless hard wearing epoxy floor coat that produce attractive aesthetic resistance to abrasion and to a appearance. Ideally suited for areas where high degree of cleanliness are required. Exceptional wide range of chemicals.

Epoxy Self level Flooring | Unnathi Enterprises | +91 9986004163 | [email protected]

Epoxy Self level Flooring

Technical Data
Maximum Operating Temperature, °C 121
Mixing Ratio By volume, (R : H) 4:1
Pot life at 30 °C , minutes 40
Full cure at 30 °C , hours 12
Coverage per coat per Ltr, Sq.mtr. 0.75
No. of coats required 1
Film thickness per 2 coats, microns 0.75
Volume of solids, % 0.75
Applied By Scrapper - Roller


  • Control room Floorings
  • Laboratory Floorings
  • Hospital clean room Floorings
  • Show room Floorings
  • Computer room Floorings
  • Bottling plant Floorings
  • Electronics production floors
  • Industrial Flooring
  • Godown / Warehouse Floorings
  • Garage / Car Parking Floors

Pack Size

  • 20 Kg.

Surface Preparation :

Surface to be coated must be structurally sound, dry, free from loose material. All surface contamination must be removed. Grease and oil should be grit blasted or water jetted. Deeper penetration must be removed by mechanical means.

Mixing :

Contents of Resin and Hardener should be throughly stirred individually to disperse any settlement which may taken place during storage. The entire contents of Hardener should be poured into Resin and the materials thoroughly mixed for at least 3 minutes taking particular care to scrap the sides and bottom of the container. Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted with mixing paddle is preferable. Follow mix ratio for part mixing.

Application :

The material is poured onto the prepared substrate and spread to the required thickness with a steel trowel, slowly and evenly. Immediately after spreading on floor compound should be firmly rolled with a spiked nylon roller to release any entrapped air in the material and level slight trowel marks.