Unnathi Groups Technology Reinvented

Epoxy Marking Parking

Epoxy based Epoxy Marking for Parking system having highest chemical resistance for protecting the surfaces under severe acidic and alkaline conditions for both interior and exterior applications and also resistant to saline, moisture, water, acids & alkalis.

Epoxy Marking Parking | Unnathi Enterprises | +91 9986004163 | [email protected]

Epoxy Marking Parking

Technical Data
Maximum Operating Temperature, °C 90
Mixing Ratio By volume, (R : H) 2:1
Pot life at 30 °C , minutes 30
Full cure at 30 °C , hours 4-5
Coverage per coat per Ltr, Sq.mtr. 0.6
Film thickness per 2 coats, microns 1200
Volume of solids, % 100


  • Control room Floorings
  • Laboratory Floorings
  • Hospital clean room Floorings
  • Show room Floorings
  • Computer room Floorings
  • Bottling plant Floorings
  • Electronics production floors
  • Industrial Flooring
  • Godown / Warehouse Floorings
  • Garage / Car Parking Floors

Pack Size

  • 20 Ltr.

Surface Preparation :

Surface to be coated must be structurally sound, dry, free from loose material. All surface contamination must be removed. Grease and oil should be grit blasted or water jetted. Deeper penetration must be removed by mechanical means.

Mixing :

Contents of Resin and Hardener should be thoroughly stirred individually to disperse any settlement which may taken place during storage. The entire contents of Hardener should be poured into Resin and the materials thoroughly mixed for at least 3 minutes taking particular care to scrap the sides and bottom of the container. Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted with mixing paddle is preferable. Follow mix ratio for part mixing.

Application :

Apply mixed materials with stiff nylon brush. The 1st coat must be firmly applied and be well scrubbed into the surface. The 1st coating should be allowed to become tack free, before applying the 2nd coat. No thinners or solvents should be added.