SELF LEVEL EPOXY FLOORING

Pack Size:                
                  25 Kg
                  

Self leveling epoxy floor coating for high impact and abrasion resistant

Extremely easy to clean, seamless hard wearing epoxy floor coat that produce attractive aesthetic resistance to abrasion and to a appearance. Ideally suited for areas where high degree of cleanliness are required. Exceptional wide range of chemicals.

 

Typical Properties

Maximum Operating Temperature, C : 121

Mixing Ratio By volume, (R : H) : 4 : 1

Pot life at 30 C , minutes : 40

Full cure at 30 C , hours : 12

Coverage per coat per Ltr, Sq.mtr. : 0.75
No. of coats required : 1
Film thickness per 2 coats, microns : 0.75
Volume of solids, % : 0.75
Applied By Scrapper - Roller :  

Applications

 Control room Floorings
 Laboratory Floorings
 Hospital clean room Floorings
 Show room Floorings
 Computer room Floorings
 Bottling plant Floorings
 Electronics production floors
 Industrial Flooring
 Godown / Warehouse Floorings
 Garage / Car Parking Floors
   
Application Instructions :(Please read general instructions)
 
Surface Preparation : Surface to be coated must be structurally sound, dry, free from loose material. All surface contamination must be removed. Grease and oil should be grit blasted or water jetted. Deeper penetration must be removed by     mechanical means.
 
Mixing: Contents of Resin and Hardener should be throughly stirred individually to disperse any settlement which may taken place during storage. The entire contents of Hardener should be poured into Resin and the materials thoroughly mixed for at least 3 minutes taking particular care to scrap the sides and bottom of the container. Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted with mixing paddle is preferable. Follow mix ratio for part mixing.
 
Application : The material is poured onto the prepared substrate and spread to the required thickness with a steel trowel, slowly and evenly. Immediately after spreading on floor compound should be firmly rolled with a spiked nylon roller to release any entrapped air in the material and level slight trowel marks.
 

#3, 1st Cross, Netaji Circle, Mathikere Ext. Bangalore - 560054,    Email: unnathigroups@gmail.com

Phone: 080 - 2276 8062            Mobile : +91 78488 14163

Copyright Unnathi Groups, All Rights Reserved